10MIDI
? See the MIDI Implementation Chart on
Adjusting Amp Settings
page 14 for details.
You can adjust any knob on the Cyber�Champa amplifier using the following
continuous controller numbers. Values range from 0=off to 127=maximum.
? Control changes can be recorded usingContinuous Parameter
a sequencer so that you can play them
Controller #Setting
back during performances.
07Master Volume
85Effects Off/On(0-63=off, 64-127=on)
? A sequencer must first capture knobs
102Gain
before it can control their settings. To
do this, ramp the continuous controller103Volume
through the full range of values, then104Treble
return it to the desired value (setting).105Middle
The sequencer will then have active106Bass
control of the knob (parameter). 107Reserved
108Master Volume
NOTE: If sequencer capture is lost (by
109Reverb Level
manually turning the knob for example)
110Reverb Time
the sequencer must recapture control
111Reverb Dwell (Input)
of that parameter to use it again.
112Reverb Diffusion
113Reverb Tone
114Modulation Effect Level
115Modulation Effect Rate
116Modulation Effect Parameter 2(see page 11)
117Modulation Effect Parameter 3(see page 11)
118Modulation Effect Parameter 4(see page 11)
119Tap Interval
120Delay Level
121Delay Time
122Delay Feedback
123Delay Parameter 2(see page 12)
124Delay Parameter 3(see page 12)
125Reverb, Multi-Effects(see page 12)
126Modulation Effect, Multi-Effects
127Delay, Multi-Effects
? See the MIDI Implementation Chart on
Advanced Effect Editing
page 14 for details.
Reverb
Reverb parameters in the figure and table below are accessible only by MIDI
continuous controller numbers 109-113 and have a value range of 0-127.
HMAL
OCC# Reverb (all)
? All 4 Reverb types have the sameOL
R
5 editable parameters.109Level
110Time
Reverb parameterSREVERB111Dwell
PA
R112Diffusion
Continuous ControllerIN
NE
numbersGAR113Tone
SPRING, ROOM, HALL, ARENA N Parameter value definitions
LevelAmount of Reverb (0 is off, 127 is maximum)
TimeDuration of Reverb sustain (0 is shortest, 127 is longest)
DwellSignal level input to the Reverb circuit (versus output level controlled by the REVERB knob). (0 is minimum, 127 is maximum)
DiffusionDensity of Reverb from sparse with non�uniform decay, to dense with smooth decay (0 is sparsest, 127 is smoothest)
ToneBrightness of Reverb (0 is darkest, 127 is brightest)
wwwwww..ffeennddeerr..ccoomm'wwwwww..mmrrggeeaarrhheeaadd..nneett |
ACEC
